2002 6 wheller polaris

hlm033 · #1 (**permalink**) 12-30-2011, 02:01 PM

I just purchased my first ATV. I guess its a UTV. 1999 Ranger 500 6 Wheeler. It does need a little work. I may be posting in the wrong area. Sorry. Started with routine service. Had a little trouble with some of the fittings but eventually got them all except two. Any idea how to get to the fitting on the inner cv shaft u joint on the drivers sIde? Also there is a center wheel hub grease fitting I cannot find. I do have a service manual but it isn't much help for these two. Anyone have any experience with this model? Next I am on to motor mounts. Thanks Gary

**Bruce!** · #2 (**permalink**) 12-30-2011, 02:47 PM

Welcome to the board!

Russ C · #3 (**permalink**) 12-30-2011, 03:58 PM

do you have a needle for a grease gun? they nake one that you put in the center of zerk and it pushes the ball in , as for center wheel hub fittings, Imm guessing they are on rear, inside hub to lube bushings, on the bottom .

2002 6 wheller polaris

first time atv buyer

first time buyer on atv's