Set of four DWT custom 15" aluminum rims. They were built for a race car that used the hubs off of a Polaris Outlaw 525.
They are spun and polished, made of high strength 6061 aluminum (.190) thick. Total use: two hours
Front rim bolt pattern: 156mm x 4
Center cutout: 5.125"
Rear rims: 110mm x 4
Center cutout: 4.5"
All bolt holes: 3/8"
They can be drilled for another bolt pattern, provided of course that the new pattern is larger than the center cutouts.The rears could be drilled to match the 4 x 156 bolt pattern of the fronts.
Rim size:
6.5" rim width, 15" diameter
3.75" backspace (2.25/3.75, 0.5 thick center)
Considerations: You will be able to mount a range of 15" car tires, provided that they are designed for a 6.5" rim. Your ground clearance will go up by at least 2.5", and maybe more depending on the tire.
Downsides: raising the ride height will raise the center of gravity, which will make the quad more prone to tipping over. Your gearing will be taller. The steering may get heavier and you may have bodywork clearance issues. Lastly, these rims are intended for racing/off road use only.
Rims: $180 obo.
Located in Santa Barbara, CA. Shipping is extra, and will be between $70 and $110. Send me a PM.
Linear Mode
