polaris forums

Mechhell · #1 (**permalink**) 07-09-2009, 04:00 PM

I just received the Handle bar mount for a Garmin Map60csx GPS, There was no room for it on the handle bars, So I removed the part that clamps on to the bars and drilled a couple holes and used some neoprene isolators with 8-32 bolts and located it by the Instrument panel. heres the Pic.

**Bruce!** · #2 (**permalink**) 07-09-2009, 04:50 PM

I went out with someone that had something like that and it came with a big suction cup and they stuck it to the speedo, then had it tied off just for extra measure and it didn't come off for a total of 50-60 miles total!

Mechhell · #3 (**permalink**) 07-09-2009, 06:02 PM

LOL 50-60 Miles!, Suction cup?. I'm hoping 2 bolts will hold long than that, But then again I was going to duct tape it

polaris forums

polaris garmin atv mount