alternatives for levers?

Ta2edphreak · #1 (**permalink**) 12-18-2011, 07:44 PM

is there something special about the levers on the 03 predators or something? i cant seem to find a set of shorty clutch and brake levers to fit the machine.
or is there any way to change the levers over to say 660/700 raptor levers? ive seen a ton of levers for some machines.
also on a side note what is a good cheap aftermarket handlebar/riser setup and how much of a rise can i do without needing longer cables?

**blueline15** · #2 (**permalink**) 12-19-2011, 08:36 AM

Its all about supply and demand. Way more 660/700 raptors then there are 03 generation preds

You likely can adapt raptor levers, you may need the master cylinder from the raptor too...not to sure what the differences are, but it likely can be done.

How much are you looking to spend for bars and raisers? The general rule of thumb for polairs snowmobiles was 2" of rise before needing cable extensions, not sure if that applies to the atvs though.