Help on a cv joint - Polaris ATV Forum
Polaris Sportsman Discussions for the Polaris Sportsman 90, 300, 355, 400, 450, 500, 550, 600, 700, 800, 850

 
LinkBack Thread Tools Display Modes
post #1 of 3 (permalink) Old 07-19-2010, 02:20 PM Thread Starter
Junior Member
 
02blk700's Avatar
 
Join Date: Jun 2010
Location: Somerset County, PA
Posts: 9
Angry Help on a cv joint

Hello, new here: I have an 02 sportsman 700. I have a bad cv boot on outside right rear. I have everything apart but can not get the cv joint apart. I have the tech manual and when I spread the ring apart and smack it, nothing. I have tried PB blaster, wd 40 and 2 lb sledge. No luck. I also tried to remove the entire half shaft but it won't release from the tranny. Pried and pried...no luck. I am sure this isn't a new prob.....

I am looking for any Techniques that might be out there.

thanks.

Last edited by 02blk700; 07-19-2010 at 02:22 PM. Reason: More detail
02blk700 is offline  
Sponsored Links
Advertisement
 
post #2 of 3 (permalink) Old 07-19-2010, 03:03 PM
Polaris ATV Junkie!
 
MUDDIE49's Avatar
 
Join Date: Jul 2009
Location: Penna
Posts: 601
Bud they both have compression rings that hold them in...your just going to have to put alittle more into it...try a large screw driver or a spoon and pry....if you can't get it out...take off the inner cv boot clip and slide the bearing out of the housing.but be careful you don't loose any bearing....rap a towel around the inner bearing...and you can always regrease the inner cv and replace the cv boot clamp...its cheaper then breaking the shaft or damaging the trans housing......Muddie49

2009 Polaris 500 HO
Front&Rear Brush Guards
2500lb Polaris Winch
2" Ez install lift kit
26inch Zillas & 14 inch ITP wheels ..
Front &Rear Extenders
Polaris hand guards
K&N airfilter box system
My FenderGuards
EPI Clutch System. 2010 camo
SunPro Temp gauge. 550xp Sportsman
Xbow Gripper mount
~DOWN&DIRTY~
MUDDIE49 is offline  
post #3 of 3 (permalink) Old 07-25-2010, 08:12 AM Thread Starter
Junior Member
 
02blk700's Avatar
 
Join Date: Jun 2010
Location: Somerset County, PA
Posts: 9
Thumbs up Got it out

After a week or so of PB and WD and prying. It poped right out yesterday the way it is sappoda. Thanks for the input. Thant half shaft was really rusted in there.
02blk700 is offline  
Reply

  Lower Navigation
Go Back   Polaris ATV Forum > Polaris Model Specific Discussions > Polaris Sportsman

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Polaris ATV Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in









Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Similar Threads
Thread Thread Starter Forum Replies Last Post
Help on a cv joint 02blk700 ATV New Members 8 08-08-2012 03:37 PM
CV joint bearings dclavell ATV Repair and Maintenance 2 05-30-2010 07:29 AM
02 SP700 CV Joint Ozquad Polaris Sportsman 2 12-19-2009 10:41 PM
Need Cv Joint help ibucarl ATV New Members 1 09-22-2009 03:29 PM
99 sportsman 500 cv joint adavis ATV Repair and Maintenance 3 08-05-2009 06:50 PM

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome