polaris trailblazer flywheel puller

21yearoldWhoLoveHisGarage · #1 (**permalink**) 03-23-2011, 10:36 AM

hey guys sorry in advance if i post in the wrong spot so iv been doing a over haul on a trail boss and am trying to replace a crank shaft seal i got 1 finished but the one behind the starting gear i cant get to iv tried everything to try to pull the Big starting gear off but it wont budge any help/tips would be great

thanks again

**Bruce!** · #2 (**permalink**) 03-23-2011, 03:49 PM

Welcome to the board!

shane-o · #3 (**permalink**) 03-24-2011, 03:05 PM

the fly wheel which the starting gear is mounted to...behind the recoil housing ? if so there are 3 holes fairly small take like a 1/4" bolt and a "steeringwheel" puller to remove that they can be tight but it is removable sorry if im misunderstanding

21yearoldWhoLoveHisGarage · #4 (**permalink**) 03-26-2011, 06:24 AM

yea your right its the starting gear behind the pull start housing and if the steering wheel thing is a tool i dont have it but if i thread 1/4 bolts threw each hole tightening them each a little till it pops it off

21yearoldWhoLoveHisGarage · #5 (**permalink**) 03-27-2011, 07:33 AM

if i thread 3 bolts threw the 3 holes its going to push against the magneto ? the gizmo with the copper wire wrapped around it and this is going to require some force so i see it causing damage to it