Polaris ATV Forum banner

oil cooling hose washers

1K views 0 replies 1 participant last post by  davecvis 
#1 ·
Magnum 330

Received oil cooling hose for replacement. There were three [all different types] washers and one O-ring loose with the packaging. When I removed the defective oil hose, there were no washers or O-ring. Do I need them ?? perhaps an improvement ?? if so where does each type washer go? The Polaris service manual diagram does not indicate that there are any washers or an O-ring from the cooler to the engine block. Can someone advise?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top