Polaris ATV Forum banner

Search results

1-5 of 5 Results
Advanced Search
  1. Scrambler 400 Pushing oil in breather hose

    ATV Repair and Maintenance
    Thanks for the Ebay listing. I will check it out and decide which route I will take. To replace or to remove... I am located in South Africa and I think shipping the oil pump to you and back might be quiet expensive but thanks so much for the offer. I might still consider it. I already had to...
  2. Scrambler 400 Pushing oil in breather hose

    ATV Repair and Maintenance
    I found the leak... So to get back to this thread and provide some information and pictures for those who might face similar problems...:wink I mentioned in my last post that I will leave the ATV standing for a day or two and observe any ingress of 2 stroke oil into the counterbalance casing...
  3. Scrambler 400 Pushing oil in breather hose

    ATV Repair and Maintenance
    Rookie mistake from my side with regards to the DenBraven Sealant... I will take note of the recommendation should I need to strip the motor down again. I also can't see that that amount of 2 stroke oil can leak via the pump shaft into the counterbalance casing. I will also investigate the...
  4. Scrambler 400 Pushing oil in breather hose

    ATV Repair and Maintenance
    Hi Latebird Thank you for the response. I am 100% sure that I installed all the seals as well as the o-rings behind the collars on the crankshaft. It might be possible that one of them got damaged (and I didn't see it) during the installation. For me it also make sense that this is about the...
  5. Scrambler 400 Pushing oil in breather hose

    ATV Repair and Maintenance
    Good day*all I am new to this forum,*I am struggling to find the relative information and was hoping that someone out there can assist me with my current problem.* Long story short, I have a 2002 Polaris Scrambler 400 2x4. I obtained the ATV as a non-runner and there was a lot wrong with it...
1-5 of 5 Results
Top