Polaris ATV Forum banner

350l

  1. 91 350L 4x4 bogging down

    ATV Repair and Maintenance
    I have a 91 350L 4x4 that runs great for about a 100yds and then starts to bog. Hold the throttle, it will bog and die as if it is out of gas. If you let off it idles fine. Idle around for a couple of minutes, throttle up again for about another 100yds, bogs down. It always starts right up and...
  2. Oil Questions 93 350l

    ATV Repair and Maintenance
    Okay last year i bought a 1993 polaris 350l from my uncle who just had it fully rebuilt due to the oil injection failing on the previous owner i bought it and immediately had to change the motor mounts and buy a new inner and outer clutch cover along with some other minor things now i got it...
  3. 1992 350L Driven Clutch Stuck

    Polaris Trail Boss
    I purchased a 1992 350L Trail Boss that I am removing the engine for rebuild. I bought the tool for removing the drive clutch and have it off but the driven clutch wouldn't budge after taking the bolt out. Is there another tool that I need for this clutch or a method that I am missing?
  4. new 91 Trail boss 350 problems???

    ATV Repair and Maintenance
    Hi I recently picked up a 91 Polaris Trail Boss 350L 2X4 quad. Quad had been sitting in a garage for roughly 3 years not being used. Bottom end was locked up when I got, recently got it unstuck and got it to start and run. To get the bottom end unstuck I pulled top end and soaked bottom end...
  5. Polaris 400 2 stroke manual

    ATV Repair and Maintenance
    I'm going to be tearing this engine apart and would like a manual. I'll be replacing the bearings/seals/gears. Any manual for a 350l or 400 2 stroke should be fine. So if you got 1 and don't mind letting me take a look at it, let me know :)
  6. how to belled/check oil injection

    ATV Repair and Maintenance
    just a 93 350l 2x4 2 strokefor cheap this weekend. would not start got spark, checked carb and needsrebuilt..kit on the way. the guy mentioned something about the oil injection being disconnected. it appeared to be hooked up to the carb and one to bottom end. how would i go about checking it or...
Top