Polaris ATV Forum banner

bearing

  1. Camshaft half moon guides?

    ATV Repair and Maintenance
    I have a 2005 Polaris Predator 500 and I'm assembling the top-end and just noticed that I'm missing one of the guides that goes on top of the bearing on the camshaft that sits between the camshaft bearing and a camshaft cover. Does anyone know what this part is called or if it can be purchased...
  2. Sportsman 600, Driven clutch

    Polaris Sportsman
    Polaris Sportsman 600 Twin started to eat belts and finally it destroyed the bearing/pushing in the secondary clutch. There was crashed metal in the box. I have the new pushing but wondering what is the function for that because it does not fit into the inner plate. Is it just hanging there on...
  3. 1996 xpress 300 need rear brake bulkhead bearing part number

    ATV New Members
    hello, I have been lurking around here for some time and have found a lot of answers here, much appreciated. But I have been unable to find a Polaris or aftermarket bearing part # for the gearcase output shaft/bulkhead that goes to the rear brake assembly. This is the same shaft that the front...
  4. Steering pivot bearing

    ATV New Members
    I bought an 03 trailblazer 250 about a week ago for what I feel was a good deal even though it needed minor things, it is my first four wheeler, but I can't find out where to get or exactly what to get for the upper steering pivot point, the lower one where the tie rods are is fine, it is the...
  5. Rebuilding my Polaris sportsman 500 CVT clutches

    ATV Repair and Maintenance
    I recently bought a used 2000 Polaris sportsman 500 4x4. The CVT belt started to shred and CVT was making a high pitch whirling noise, so I decided this was a good time to do maintenance on the clutches. I bought an EPI clutch kit and an EPI severe duty belt because I drive through a lot of...
  6. 02 sportsman 500 front strut knuckle

    Polaris Sportsman
    I have a 2002 sportsman 500 and i see that the front strut bearings use tapered roller bearings instead of ball bearings like the newer 04-09 models and i was wondering if i went ahead and got some front knuckles from an 04 or up if the diameter of the cv axle would be a different size than the...
  7. Polaris 400 xplorer 2 stroke bottom end

    ATV Repair and Maintenance
    A friend and I started rebuilding this(his) bike, a 1995 Polaris 400 xplorer. It ran great up until recently. I decided to tear the top end down and take a look at it. Seized up 6 points and had a stuck ring for starters. We've premixed our own gas/oil with a 40:1 ratio. We've also plugged...
Top