Polaris ATV Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 123 Results
  1. ATV Repair and Maintenance
    I’ve replaced stator, flywheel, cdi box, voltage regulator, starter, coil, spark plug and still not getting any spark. I bought 6 months ago and trying to get it running. There is also a white/red wire coming from front that I can not find where it plugs in at. Previous owner eliminated thumb...
  2. Polaris Scrambler
    I've been fighting this thing for a while now, things that I've replaced: radiator, coolant overflow orifice, new jug, piston, water pump seals, resurfaced the head, head gaskets, tusk temp radiator cap. With all of this done I'm still getting coolant that is coming out by my left leg at the...
  3. ATV Oil, Lubrication & Filter
    So Ive just rebuilt a 2000 Polaris Scrambler engine and I was wondering what I need to do for an oil change. I know you need to put 70-75cc of oil into the counter balancer but there’s also a fill hole on the recoil. So where else do I need to put oil into the engine?
  4. ATV Repair and Maintenance
    Looking to swap engines, here’s a little introduction. Picked up a flawless condition 1989 Sportsman 400. Got it knowing the little 2 stroke was hurting, and before I got a chance to rebuild it the skirt of the piston wore thin, it peeled off then fell down between the crank and the case...
  5. ATV Repair and Maintenance
    2019 Scrambler 850 popping noise through intake at idle this only occurs at idle has plenty of power driving. Had new rings and pistons installed whenever it was all put back together its running this way. Checked timing and it's right also checked valve adjustment and it's correct. Anyone have...
  6. ATV Repair and Maintenance
    Good evening, Seeing if anyone with a manual can tell me the correct valve clearance for a 2016 Scrambler 850. Im adjusting valves before the trip to HMT and just need specs. I know the process on how to adjust and all. Thanks for help. 2016 Scrambler 850 Full Big Gun EVO U Big Gun fuel...
  7. Polaris Scrambler
    I am in need of replacing my ignition coil on my 2006 Scrambler 500 4x4. In the parts breakdown the part number is 3089260. Is there a new parts number or a new ignition coil that I can put on my 2006 Scrambler? I have looked on ebay used ones I have found are $100 or new ones around $200+ and...
  8. ATV Purchasing and Price
    As the title says, I've got a 1986 Polaris Scrambler 250R/es 3 wheeler it's been sitting in storage for 20 years. It's not mine it is my girlfriend's family's ATV. Her father put it in storage broken not sure what's broken and never got around to fixing it. Other than the engine being "broken"...
  9. Polaris Scrambler
    Hey all, I’m considering replacing the entire engine on my Polaris Sport 400. I’ve sourced out a motor but it came off a Scrambler 4X4. The question is, will it mate up to my 2X4 transmission? I’ve been searching for answers but haven’t found anything.
  10. Polaris Scrambler
    Hey all, by any chance does anyone know the size of the head studs for these machines (1998 Sport 400L) I wanna say it’s 8mm X1.25? Just making sure.
  11. Polaris Scrambler
    Doe any know if there is an o-ring at the end of the pilot screw for the carburetor? Service manual says there is supposed to be, carburetor didn’t have one installed. Parts diagram does specify one on the end of the pilot screw.
  12. ATV Repair and Maintenance
    Alright so I will try and make this quick and to the point. But basically I’ve had this machine for over 6 years and haven’t been able to get it to run right… I had the whole engine rebuilt. Checked very fluid. Replaced everything major I could see. Even tried mixing gas and bypassing oil...
  13. Polaris Scrambler
    Good evening all, With regards to the intake tube on the 98 Polaris 400 Sport, is there an o ring that goes between the intake tube and reed valve? Service manual says to put a new one in, but I don’t see where it would go?
  14. ATV Parts for Sale
    I'm parting out a 2002 polaris scrambler sport 400 2 stroke. Currently have everything except for radiator, rear caliper, starter, and magneto. Has new front calipers and tierods. No bends in rims. Steering post is bent. Let me know if you need anything.
  15. Polaris Scrambler XP
    Okay this is what I’m dealing with went to start my 2014 Polaris scrambler 850 it would not start check few things out and changed the spark plugs got it running but runs super Rich and rough I can pull the pto plug wire off and motor does not change I pulled spark plugs back out and pto side is...
  16. ATV Repair and Maintenance
    i have a 1996 polaris scrambler 400 4X4 and it is not running properly as it will not rev up nicely and won’t get to dull rev as well as it won’t idle, it has a small exhaust leak and it is basically stock, i replaced the oil tank and reads, and it’s still will not run properly please help
  17. Polaris Scrambler
    Hey i'm new here. 2 weeks ago i picked up a project scrambler 400. Got it all running fine, as it needed carb work. They way it was, the left side wheel would engage when you hit the 4x4 switch, but the right didn't. Also, if you try to put the machine in reverse, it will die unless you push the...
  18. ATV Repair and Maintenance
    Hello everyone. I have a 2015 scrambler 1000 I just picked up and the belt (or something) is making the belt slip. Anyways I noticed it only slipped when I use full throttle. It makes this weird clunk sound almost as if the belt goes around but doesn’t catch and then catches again and slams the...
  19. Polaris Scrambler
    I just purchased a 1995 scrambler 400 4x4 that i am trying to give some TLC to. It starts great and will idle great, but trying to rev up the throttle just makes it bog and it wont actually rev up. Also if you throw it in gear you cant get it to move. This all happens until it has warmed up for...
  20. Polaris Scrambler
    Hey all. I’ve searched and searched with no real answers. 03 Scrambler 50 started bogging down, spitting and sputtering while riding last year. It finally quit and put in the barn til recently. I’ve replaced cylinder (120 compression) piston, stator, ignition coil, carburetor, starter and...
1-20 of 123 Results
Top