Polaris ATV Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
Did a complete and thorough frame-up rebuild over last several years...only got to put around 5 hours on it last year, including proper break-in.

Most parts powder coated or painted...rath reinforced frame
professionally built engine ronnie wilson of ronnie wilson racing...he was sponsered by polaris a few years back]...it has all new steel and fiber clutches, billet water pump shaft, 12:5-1 comp, lightened flywheel, new cylinder, fcr flat-slide carb. Conversion, stock header [ceramic coated] w/hmf race slip-on...est. Close to 50 hp!

All new maier plastic...white carbon fiber look, chrome-moly anti-vibe stem with fat bars., AFTERMARKET FRONT BUMPER AND REAR GRAB BAR, hardened tie rods w/heim joints, tapered bearing conversion on front hubs, new sti 6 ply cc tires on front...stock on rear...stock wheels,
anti-slip seat cover w/extra padding. Fox shocks all done up professionally [again rw] with triple fronts and rezzies, and dual rear springs.

Aluminum air box, with foam filter, 2 billet aluminum coolant tubes, aluminum radiator scoops, tusk aluminum heel guards, stainless steel fasteners throughout, meticulous detail involved to insure longevity.

Close to $10k spent...asking $3500 obo

located outside kansas city, mo...zip 64080...will deliver up 100 miles of listed zip for free.

Have title of origin...but the original owner messed it up and vin was blasted away from sand blasting.
Pm phone number any more details can be discussed.
Not looking to trade...already have enough toys.
 

Attachments

·
Registered
Joined
·
630 Posts
Very nice you did a great job restoring it..
 
1 - 2 of 2 Posts
Top