Polaris ATV Forum banner

05 700efi electrical issue sitting duck.

2956 Views 6 Replies 3 Participants Last post by  Richards6692
Hello everyone. I am having issues with my quad. 05 700 twin efi. I was using the winch one afternoon and the battery light flashed on the gauge. So I stopped using winch. Revved up a lil bit and then died. No power. Battery tested good. Stripped down and inspected wires etc. my fuse block on far left 20a fuse has no power on either side. Kill switch is on run position. I have one hot wire at ignition switch nothing else works. Got new switch and key and still same thing. If I jumper wire the one side of that fuse slot everything lights up etc. is this an issue that has happened to someone else. I'm at my whitts end. Been reading all sorts of stuff on here and havnt found anything that helped. Any advice or help is greatly appreciated. Thank you for your time.
1 - 2 of 7 Posts
Looking at the wiring diagram , there should be a fusible link located on the starter solenoid battery terminal that feeds the fuse block . Look for a black wire from the solenoid that goes into a fusible link with a red wire on the other side of the link going up to the fuse block .
Fuse on the far left , 20 amp , is fed from the fusible link at the starter solenoid , it's for acc. power . The fuse next to it , 20 amp , second from left is for chassis power , this is the one you need to trace out .
Yellow wire from it should be 12 volts to the key switch , when you turn the key to on position you should have 12 volts going out on the red/black wire .
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top