Polaris ATV Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello, I have an 06 Scrambler 500 4x4, and the left front wheel doesn't work in 4x4. I replaced the armature plate, it still didnt work. I am guessing now its the magnet that is in the strut, and I've been looking for a new strut (I've read that its way easier then replacing the magnet), but I can't find one thats for an 06. So my question is what other years will fit? Also, when I have it up on a stand in 4x4, the handlebars jiggle back and forth when you apply throttle. I'm assuming this is because of the same issue? Is there anything else I should look at before I go and buy a new strut? Thank you.
 

·
Registered
Joined
·
1,097 Posts
Check for power and ground first. Also check the magnet for continuity with a multi-meter. Could be a front clutch hub.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
Thanks for the reply! how do I go about the multimeter deal? I'm not super mechanical and haven't used one a whole bunch.. Normally I can figure stuff out if I set my mind to it though. lol
 
1 - 3 of 3 Posts
Top