Polaris ATV Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
good day! new member, 1st post, bear with me. purchased an 02 500ho 4x4 recently, mounted new winch, started installing wiring harness, all went well but....directions say to connect handle bar switch and remote 12' switch "hot" lead to load side of fuse feeding master switch on atv. found a red lead going into black rectangular sealed pouch in behind headlight housing. is this the correct wire (side towards switch)?? also, looking at site and found area for downloading a manual but not sure what or how to do this. any help would be great. thanks
 

·
Registered
Joined
·
1,097 Posts
Welcome to the forum!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top