Polaris ATV Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
The front brakes have gone out on my Polaris. After looking at some online forums and doing some troubleshooting myself I think something is wrong with the master cylinder. When I squeeze the brake handle it mashes all the way down without any resistance. I really don’t want to replace the entire assembly if only one part of it went bad. Does anyone have any thoughts on what it could be? I took the cap off of the master cylinder holding it just over the top so nothing sprayed out and pressed the brake handle. Brake fluid shoots up while the handle is being squeezed. And there are no visible leaks anywhere. Any help would be greatly appreciated, thanks in advance
 
1 - 3 of 3 Posts
Top