Polaris ATV Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I would like to install a seat/storage box but I'm nervous about plastic bolted to plastic. Is there a better way to install seat/storage box. Any suggestions would be appreciated
 

·
Premium Member
Joined
·
20,001 Posts
Welcome to the board.
 

·
Registered
Joined
·
1,009 Posts
I just bought my second wes industries box from theatvsuperstore a couple of weeks ago.. The lock'n ride system works very well.. The box does not bounce around or come loose.. My son rides with me and the box holds him perfectly..

The one I had on my 850 touring did mark up my rack a bit where the bottom contacted it.. It wasn't bad mind you but it was noticable when the box was off.. I'm a bit looney about keeping my machine(s) as close to like new condition as I can, so this time, I put two layers of simple electrical tape on the bottom of the box where it contacts the rack.. Not a mark on it so far..

Here's a pic of the one I had on my touring and the one I now have on my 570..


 
1 - 4 of 4 Posts
Top