Polaris ATV Forum banner

2016 850 high lifter wont start please help!

4K views 11 replies 4 participants last post by  gearheadesw1 
#1 ·
Hi guys so I have put a big gun slip on exhaust and it ran ok but I thought with the big gun programmer it would be better. So I installed it tried to start the machine it would not start. I pulled plugs and it only received a spark or two then flat nothing.
I replaced plugs and just put a new stator in a week ago and ran fine I was out doing wheelies the day before. Now after cranking it over it popped the 10 amp fuse and one of the coil packs melted. I unplugged it bought a new coil pack and replaced the fuse and then plugged the injectors back to normal (No programmer)
I have checked grounds and even the throttle sensor. Still only a spark or to then flat nothing. Can anyone please tell me what else to look at I looked at fuses and relays seem fine.
 
#3 ·
what do you have for voltage at the battery with the machine running @3,000rpm??

*make sure the battery terminals are good and tight before you test!!
 
#6 ·
what test did you perform?? voltage, continuity, resistance??
 
#9 ·
sounds like that the problem. how many terminals are in the connector??
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top