Polaris ATV Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #1 ·
Does anyone know of anywhere that is selling a pull skid plate for the 570 touring? I found a arm protectors but not a full setup like Ricochet? Thanks in advance. I can't find a full set anywhere. May not be out yet:bam:.
 

·
Registered
Joined
·
51 Posts
Discussion Starter · #3 ·
I did not call them but I emailed them. No response yet. I'm sure it's just time since its a new machine- they will have something. I just didn't know if anyone knew of any that were out now. Thanks!
 

·
Registered
Joined
·
51 Posts
Discussion Starter · #5 ·
Ha thanks me too!
 

·
Registered
Joined
·
7,469 Posts
you could always make your own. It's not hard.
 

·
Registered
Joined
·
51 Posts
Discussion Starter · #7 ·
Hmm.. never thought of that, what is everyone using?
 

·
Registered
Joined
·
7,469 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #9 ·
Good article but I think past my ability and owned tools.
 

·
Registered
Joined
·
7,469 Posts
Good article but I think past my ability and owned tools.
Nothing that I did couldn't be done with a Jig saw and a drill. If you buy a full sheet of Aluminum you wont need to weld. and the bends were done with a heavy table and a section of angle iron and a hammer. but a tailgate, bumper, structurally sound wall could all be used to be the supporting member of for the bend. Trust me, it's not that hard. looks far more intimidating than it actually is.
 
1 - 10 of 10 Posts
Top