Polaris ATV Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I just replaced the left front CV Boot..whats the best way to get the axle shaft back in the hub...split it or are there tricks I dont know..Im a novice...put a new seal in..should i have put the shaft through the hub first..but any suggestions how i can now...the strut just does not come out far enough.. Thanks for any help.
 

·
Registered
Joined
·
5,753 Posts
How'd you get it out if you can't get it back in? I usually just pop out the lower ball joint, and turn the hub and the end of the shaft and pop it in then straighten out.
 

·
Premium Member
Joined
·
20,001 Posts
Welcome to the board!:med:
 
1 - 3 of 3 Posts
Top