Polaris ATV Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
cant get the middle axe out or 94 big boss 6x6 . the book says you are to move out from right to left side with a few taps of the old rubber mallet. i removed the nuts and tapped tapped tapped then read the book some more and more tapping ...... well 45 minuets later I am slipping on the floor from the PB blaster dripping off it and the big old ball peen i upgraded to now has both sids of the axle shaft mushroomed over ........ geesh it's never easy....
feels like it moves 1/2 inch either way and stops dead ??? Any ideas
 
1 - 1 of 1 Posts
Top