Polaris ATV Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Recently picked up a trashed 07 predator 500, and have been fixing it up. everything is completed at this point except minor things. There is no rear brake switch to activate the brake light, and there is no brake light itself. I have a brake light and switch ready to go on, but I can't figure out how to wire it all up. there are 3 connections on the light, and I am not sure where they lead to, or where to mount the switch, as there are no obvious fastener holes. Apologies for posting what might seem like an obvious question, but if you knew the previous condition of this predator, I'm sure you guys would understand. Thanks!
 

·
Premium Member
Joined
·
20,001 Posts
Welcome to the board!:med:
 
1 - 2 of 2 Posts
Top