I just received the Handle bar mount for a Garmin Map60csx GPS, There was no room for it on the handle bars, So I removed the part that clamps on to the bars and drilled a couple holes and used some neoprene isolators with 8-32 bolts and located it by the Instrument panel. heres the Pic.
I went out with someone that had something like that and it came with a big suction cup and they stuck it to the speedo, then had it tied off just for extra measure and it didn't come off for a total of 50-60 miles total!
LOL 50-60 Miles!, Suction cup?. I'm hoping 2 bolts will hold long than that, But then again I was going to duct tape it:laughing:
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Polaris ATV Forum
876.5K posts
113.2K members
Since 2008
A forum community dedicated to Polaris ATV owners and enthusiasts. Come join the discussion about Rangers, Sportsmans, Scramblers, Magnums, and others. Research modifications, troubleshooting, maintenance, and more!