Polaris ATV Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
In order to minimize water entry and extend the life of the rear lower a-arm bushings in my 2006 Sportsman 450, I installed grease zerks in the bushing housings. The zerks must be installed dead center in the housings, since there is only about a tenth of an inch space between the bushings.
136110
 

·
Premium Member
Joined
·
1,226 Posts
Nice Job..... That will help!
 

·
Registered
Joined
·
87 Posts
Nice job but are those on the bottom of the a arm? If they are, I’d think they get ripped off with the first log or rock you’d climb over


Sent from my iPhone using Tapatalk
 

·
Premium Member
Joined
·
7,569 Posts
Yeah that ain't gonna last long!!!!
 
1 - 6 of 6 Posts
Top