Polaris ATV Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I am the proud owner of a 2020 Ranger 500 and have a winch (non-Polaris) I'm trying to install. The winch diagram indicates tying into the ignition switch hot wire - I assume to allow the winch to work when the switch is on, i.e. when the motor is running. Attached is a picture of the ignition wiring. Does anyone know which wire to tie into or have a diagram to refer to? Thanks - Doug
 

Attachments

·
Registered
Joined
·
4 Posts
I don't have a Ranger, but I did wire a start push button on my Sportsman. I used the A and B slots of the ignition. I looked at the wiring diagram for your year of Ranger and if I read it right, Red is your hot.
 
1 - 2 of 2 Posts
Top