Polaris ATV Forum banner

light problem

2K views 3 replies 4 participants last post by  mkeddie 
#1 ·
I have a 98 sportsman 500.....up hunting it blew all lights, and I don't know why......I started it as usual, and when I went to turn on lights, the switch switched from low to high beam, but no lights. When I checked, all lights were burnt out! Any idea's.......or is this another, "Qwerk" of owning a polaris?
CJ
 
#3 ·
i dont have to much knowledge on this or even know anything about what lights u have installed or anything but mabye you had a volt spike and put out to much power for your lights mabye try running in diagnostic mode and watch your volt meter
 
#4 · (Edited)
to much power going to the bulbs will blow them out
did they light up for a sec atleast they should have given some light before they went out or they were out before then
like gangle said take a volt meter to the bulb leads see what the power is to them
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top