I've been thinking about getting the auto stop for my sportsman but I have a warn vantage 3000 winch. This setup should work with any winch I'm assuming. Looks like basically easy wire connections. There should not be anything different from a warn to a polaris winch. Does anyone know if I am correct.The 2500 and the 3500 install the same way. You get a wiring unit in the kit that has 4 leads:
- One connects to the fairlead
- 2 connect to the existing winch thumb controller (routing the winch controller through the unit. one in from the controller, one out to the winch)
- Last one connects to power/and ground - by the terminal block. This was the tricky part for me, cuz you want it plugged into "keyed" power only, not the red/hot terminal block itself since that is always hot. The instructions that came with kit are very vague, but did mention to look for an orange/white wire the would be for "keyed" power. Finally, I saw them - on the 2015 there are two pre-wired open orange/white wires, just waiting to plug something into. Done!