2001 Magnum 325 4x4. I was wondering if anyone has used a flexible shaft screwdriver for adjusting the pilot screw? I have seen a bunch of them online but they look to big. I have seen a thumb screw adapted on this forum, but that won't work as I can't get two fingers in there.
I see motion pro makes a tool just for that purpose for about $25. But I read a review that said it didn't fit the Polaris cv carb. Anyone use that?
I have been using a fuel hose with a flat blade bit in the end, but it's awkward.
Or do I just set it at two turns out and forget it? It idles fine at two turns.
I see motion pro makes a tool just for that purpose for about $25. But I read a review that said it didn't fit the Polaris cv carb. Anyone use that?
I have been using a fuel hose with a flat blade bit in the end, but it's awkward.
Or do I just set it at two turns out and forget it? It idles fine at two turns.