Polaris ATV Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,968 Posts
Discussion Starter #1
Anyone have any luck using a thumb heater with a throttle extension installed?

I have the Polaris grip & thumb kit on my 700.

I need to figure something out on the 550 with a Kolpin thumb extension that the wife likes having.

If you have a specific brand (Symtec, Tusk, Polaris, etc) that works with a thumb heater please let me know.

Thanks!
 

·
Registered
Joined
·
729 Posts
What is preventing it from working ?
I imagine as long as you hold the throttle in the wide open position when you secure the wire to the handle bars it should work normal.
I had the symtec heat demons and the wires leading into the grips don't have any rubber molding around the wire to support it or resist it from pulling out.
I replaced them with TUSK Heated Grips/Thumb warmer- much better quality. Rocky Mountain ATV/MC - $55 to my door !
 

·
Registered
Joined
·
1,968 Posts
Discussion Starter #3
This was more of a "are there any issues?" thread. It sounds like it really isn't an issue unless you take the thumb extension off and would then need to re-do stuff.
 
1 - 3 of 3 Posts
Top