Yep. Just clean it up. Practice on a piece of similar scrape metal to get your heat and wire feed set correctly and then weld it up. Let it cool a few minutes, clean up the weld and then spray a little black gloss Rustoleum on it... Done.
Yeah, that thin tubing is sometimes hard to do without burn through even if you weld quite a bit. Just a series of spots alternating top/bottom/top/bottom etc. will stitch it up just fine too. Its really not that hard.
A forum community dedicated to Polaris ATV owners and enthusiasts. Come join the discussion about Rangers, Sportsmans, Scramblers, Magnums, and others. Research modifications, troubleshooting, maintenance, and more!