Polaris ATV Forum banner
81 - 90 of 90 Posts
So Im new and I have the dreaded "E" on my speedo (2004 ATP500) I have replaced the rotory trans switch and that didnt do it I read somewhere its grounded by the starter soleniod? I will check that next. Any suggestions?
 
I sent you the service manual.

The ignition system consists of the stator, cdi box, coil, spark plug, spark plug cap, flywheel and the wiring connecting the components.
Dear Mr Lateburd: Is there anyway you could send me that service manual? I have just purchased a very well uses 2004 ATP 500 and I am likely going to need it.... Alot lol. Please and thanks!
 
Dear Mr Lateburd: Is there anyway you could send me that service manual? I have just purchased a very well uses 2004 ATP 500 and I am likely going to need it.... Alot lol. Please and thanks!
Welcome to the forum
 
Sent the entire manual - it was faster than just the wiring diagram
Hello,
I'm new to the Forum and have been using information to work on a 2004 Sportsman 500 HO early model that hasn't been operational for 4 years. Started by replacing the carb and starter. It runs great so far but the high beam is not working and when you put it in 4WD it works but it cuts power to the dash display. I checked wiring under the headlight pod and there are two broken wires, a yellow and a brown/white wire.
Is it possible to get a wiring diagram so i can fix the electrical issues?
 
Hello,
I'm new to the Forum and have been using information to work on a 2004 Sportsman 500 HO early model that hasn't been operational for 4 years. Started by replacing the carb and starter. It runs great so far but the high beam is not working and when you put it in 4WD it works but it cuts power to the dash display. I checked wiring under the headlight pod and there are two broken wires, a yellow and a brown/white wire.
Is it possible to get a wiring diagram so i can fix the electrical issues?
Welcome to the forum
 
Hello,
I'm new to the Forum and have been using information to work on a 2004 Sportsman 500 HO early model that hasn't been operational for 4 years. Started by replacing the carb and starter. It runs great so far but the high beam is not working and when you put it in 4WD it works but it cuts power to the dash display. I checked wiring under the headlight pod and there are two broken wires, a yellow and a brown/white wire.
Is it possible to get a wiring diagram so i can fix the electrical issues?
Sent the manual to your email address
 
81 - 90 of 90 Posts